Electronics Bench

From ProtoLab Wiki
Revision as of 14:58, 5 April 2019 by Jricker (talk | contribs)


Soldering Irons

If you'd like to learn how to solder, check out the beginners guide here: https://www.makerspaces.com/how-to-solder/. This section will focus on information about the soldering irons we have.

Our electronics benches are equipped with Weller WES51 soldering stations connected to Weller soldering irons. Our soldering station has a variable temperature, the number on the dial is 1/10th of the actual temperature of the iron in Fahrenheit. For example, when soldering through hole components you'll want to set the dial to 70 which represents 700 degrees Fahrenheit.

Make sure you always put down butcher paper before you start soldering, solder can easily ruin our nice wooden tables

Desoldering Tool

Our desoldering tool is a Hakko FM-2024. The purpose of this tool, as you can imagine, is to remove solder. You'll use the end of the tool to heat up the joint, and pull the trigger when the solder is liquefied to suck it into the gun. This deposits the solder into the insulated orange canister you'll see at the top of the gun. This chamber can easily be replaced when full, and can be checked by simply pulling the yellow guard back towards the gun. The guard will click into place, and you can remove the orange canister. When you replace the canister into the gun, simply hit the yellow button on the top of the gun to release the spring.

Step Up & Down Transformer


SMD Rework Station