Difference between revisions of "Cordless Drill"

From ProtoLab Wiki
(Active Use)
(Safety Instructions)
Line 32: Line 32:
  
 
Throughout operation, apply proper pressure to the drill - not excessive. Peck drill for harder materials or longer holes if necessary. Use a center punch to start holes, and drill smaller pilot holes before attempting large holes.
 
Throughout operation, apply proper pressure to the drill - not excessive. Peck drill for harder materials or longer holes if necessary. Use a center punch to start holes, and drill smaller pilot holes before attempting large holes.
 
===Clean Up===
 
Sweep/vacuum any debris and clean/deburr any holes and put away drill bits & countersinks that were used.
 
  
 
<br clear=all>
 
<br clear=all>

Revision as of 17:06, 16 December 2019

Ryobi drill 1.jpg

A cordless drill is an electric drill which uses rechargeable batteries. Drills are primarily used for drilling circular holes in material, or for inserting screws and other threaded fasteners into material.

Drills are also available in the impact driver configuration, high-torque tools primarily used for driving screws and tightening nuts. Impact drivers can be especially useful when driving larger fasteners or driving into harder, more dense materials.


Machine Details


Common types of drill bits.

common drill bits1.jpg





Safety Instructions


Always Wear Protective Eyewear. Avoid Baggy/Loose Clothing. Loose sleeves, jewelry and hair can be a hazard when you are operating a power drill.

Preparation

Secure Your Work Piece. Insert and properly set your drill bit. Hand tighten chuck and make sure bit is spinning concentrically before tightening.

Active Use

Ensure drill is set to proper rotation before beginning. Adjust the clutch according to material hardness - the lower 1 setting for driving screws or other fasteners, while the 2 setting can be used for drilling holes into your material.

Throughout operation, apply proper pressure to the drill - not excessive. Peck drill for harder materials or longer holes if necessary. Use a center punch to start holes, and drill smaller pilot holes before attempting large holes.


Best Practices


Depending on the diameter of the drill and the hardness of the material being drilled it may be necessary to adjust the rpms of the spindle. Typically it is not good practice to mount larger drill bits (over .5") on a cordless drill. The amount of torque required to spin and produce the hole can sprain the user's wrist.